Options

Infra Red Eye Injection Kit For Long HDMI Cables (to Control Source from another room), HDMI Splitters and Matrix Switches

My cart

Infra Red Eye Injection Kit For Long HDMI Cables (to Control Source from another room), HDMI Splitters and Matrix Switches
[Complete_IR_Injection_kit]

Infra Red Eye Injection Kit For Long HDMI Cables (to Control Source from another room), HDMI Splitters and Matrix Switches
R422.68
Share Product

Introduction

The HDM IRK is a device that when added to a splitter or matrix, enables the user to control an HDMI source remotely,  from a location next to a TV connected the splitter. It uses the IR backward channel on the splitter to do this.

Connection & Set up

The diagram below shows the recommended connection method.

IR Transmitter

  • Connectt the IR transmitter to a 3.5mm jack socket output on the splitter/ matrix.
  • Position the IR transmitter module in front of the source device, with clear line of sight to the source's IR sensor window.

IR Receiver

  • Position the IR receiver within clear line of sight of the position at which you will be using the source'a remote control. Uncoil the connecting cable.
  • The splitter/ matrix should already be connected to the TV with an HDMI cable.

IRK HDMI Adaptor

  • Disconnect the HDMI Cable from the TV an replace it with the IRK HDMI adaptor.
  • Connect the HDMI cable to the IRK HDMI adaptor.
  • Connect the IR receiver cable to the IRK HDMI adaptor using the 3.5mm jack socket, Labelled 'IR RX'.
  • Ensure the two-way switch is set to 'IR'.

Pack Content

  • 1 x Infra Red receiver (marked RX) with 3.5mm jack
  • 1 x Infra Red transmitter (marked TX) with 3.5mm jack
  • 2 x HDMI Adaptor - with CEC/IR slider switch

 

HDMI_IR (Infrared)_Injection_Kit_Sample_Diagram

This product was added to our catalog on Tuesday 27 August, 2013.